BluBear® Ice Shaver with Foot Switch – Gold Medal #2747-00-100

Serve soft, snowy shaved ice with the Gold Medal BluBear ice shaver #2747-00-100, featuring adjustable texture and an attached foot switch. Its approximately 3 lb hopper accepts cube ice, giving concession operators a practical way to prepare frozen treats without relying on whole ice blocks.

Adjust the blade setting for fine flakes or a coarser texture to suit your menu. Foot-switch operation leaves your hands available to position the serving cup beneath the chute. The blue-and-white countertop unit measures 13 inches wide, making it suitable for a concession counter or restaurant dessert station. Allow 28.3 inches of clearance with the lid open.

For longer service periods between refills, add the optional #2748-00-100 hopper extension, sold separately. It increases approximate ice capacity to 12 lbs. Broken block ice can also be used when pieces measure approximately 2–3 inches.

Key Features

• Adjustable ice texture: Change the blade setting for fine flakes or coarser shaved ice.

• Attached foot switch: Control shaving while positioning the serving cup beneath the chute.

• Approximately 3 lb hopper: Load cube ice or appropriately sized pieces of block ice.

• Optional capacity expansion: The separately sold #2748-00-100 extension increases capacity to approximately 12 lbs.

• Included drainage components: A drain hose and clamp direct meltwater to a suitable drain or collection basin. 

Specifications

Setting Up the BluBear Ice Shaver

1. Unpack – Lift the unit out of the carton by the base of the blue top housing, and check that the drain hose, clamp, foot switch, and manual are included. 220–230V units also include a detachable power cord.
2. Attach the drain hose – Turn the unit on its back, push the hose onto the drain fitting on the bottom, and tighten the clamp.
3. Position the unit – Set it on a level counter, run the drain hose down to a bucket or floor drain, and place the foot switch on the floor.
4. Check blade alignment – Look up into the ice chute and confirm the blade is aligned before the first use. The manual covers adjustment.
5. Register – Fill out the warranty card or register online with Gold Medal.

FAQ
Where does the meltwater go on a BluBear ice shaver? Meltwater drains through a fitting on the bottom of the unit. Connect the included drain hose with its clamp and run it to a bucket or floor drain below the counter, so the drip tray doesn’t overflow during service.

Frequently Asked Questions

What type of ice does the BluBear ice shaver use? It accepts ice cubes or block ice broken into approximately 2–3-inch pieces. Oversized pieces will not enter the shaving chute.
How much ice does the hopper hold? The standard hopper holds approximately 3 lbs. The optional #2748-00-100 Ice Hopper Extension increases capacity to approximately 12 lbs. and is sold separately.
Can I adjust the shaved ice texture? Yes. Turn the blade adjustment knob clockwise for finer ice or counterclockwise for a coarser texture.

The BluBear combines adjustable texture with foot-switch control for a practical commercial shaved ice setup.
Ideal for: Amusement Parks, Festivals, Carnivals, Arenas, Restaurants, Bars, and Concession Stands.

Complete your station with snow cone and shaved ice supplies.

How to Set up & Operate the Blu Bear Ice Shaver 2747-00-100

2747_Series_BluBear_Ice_Shaver_Quick_Start_Guide_110249

OLDER MODEL 2700-00-000 Information:
 Setup and Operate the BluBear 2700-00-000 Ice Shaver Setting Up and Making Frozen Treats with the Gold Medal 2700-00-000 BluBear Ice Shaver